iManager NetEco 6000
Device Installation and Commissioning Guide
Copyright © Huawei Technologies Co., Ltd.
Figure 7-18 Removing a camera
Step 3 Disconnect the monitoring network cable and remove the camera from the control ceiling.
Step 4 Install a new camera, reconnect the network cable, and secure the camera to the base using
screws.
Step 5 Adjust the camera coverage based on video images.
Step 6 Tighten the screws on the front cover of the camera.
----End
Follow-up Procedure
Check whether the new camera works properly and adjust the camera angle. If video images
are properly displayed on the video screen of the management system client, the new camera
works properly.
7.2.6.4 Replacing an IPC6225 camera
Prerequisites
A camera needs to be replaced.
Spare dome cameras of the same model are available and functional.
Procedure
Step 1 Loosen the four ST39 tapping screws on the camera.
To Next Page
Loading...
Need help?
General