Huawei iManager NetEco 6000 User Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
6 Adding Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
224
Table 6-35 Parameter description
Parameter
Description
Name
Device name
IP Address
Set this parameter to the IP address of the collector to which the
device is connected.
Port
Set this parameter to the port through which the device connects to
the collector.
To learn ports on the ECC collector, see Setting RS485 Parameters
for the ECC500 V6 Collector.
After an Access Controller is created, its information is displayed in the list, as shown in
Figure 6-77.
Figure 6-77 Checking the access controller information
After the access controller is added, format it manually in the access controller list to avoid
failure in initializing the access controller.
----End
6.4.3.4 Formatting an Access Controller
This topic describes how to format access control cards, historical records, timezones, and
holidays.
Prerequisites

You have logged in to the NetEco client by web browser

You have the operation rights for Access Control Management.

Huawei iManager NetEco 6000 Specifications

General

Brand	Huawei
Model	iManager NetEco 6000
Category	Server
Language	English