Huawei iManager NetEco 6000 User Manual

iManager NetEco 6000
Device Installation and Commissioning Guide
6 Adding Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
164
Figure 6-32 Setting SNMP parameters_04
8. Input the NetEco server IP address in NMS addr, set Permission to Write, write 162 in
Trap port, click Add.
Figure 6-33 Setting SNMP parameters_05
9. Click Submit.
----End
6.3.4.2 Setting UPS5000 Monitoring Parameters (over SNMP)
Prerequisites

You have obtained the IP address, subnet mask, and default gateway planned for the
UPS5000.

The UPS5000 is powered on.
Context

Before connecting the UPS5000 to the NetEco, set the IP address on the UPS5000, and
add a user and set rights on the UPS5000 WebUI.

UPS WebUIs may vary slightly depending on the UPS software version. Perform
operations based on the actual WebUI.

The non-encryption algorithm used in UPS5000 poses potential risks. Therefore,
exercise caution when deciding to use the non-encryption algorithm.

Huawei iManager NetEco 6000 Specifications

General

Brand	Huawei
Model	iManager NetEco 6000
Category	Server
Language	English