Linhai Mini 80 User Manual

CHAPTER 5 FINAL DRIVE ATV SERVICE MANUAL 09.0
CHAPTER 5 FINAL DRIVE. 5-
4
bearing for moisture, dirt, or corrosion, or
roughness is evident.
5.3 a. FRONT HUB ASSEMBLY (ATV150/200/260/300)
1. Drive or press one new bearing in
to hub using a bearing driver (2WD).
2. Drive or press the other bearing into hub until
seated against the hub shoulder (2WD).
3. Coat the new bearing with grease (2WD).
4. Coat the spline with grease (4WD)
5. Install new seal into hub (with numbers facing
out) until flush with end of seal bore. Do not
damage the surface of the seal. Coat the
lip with special grease.

Linhai Mini 80 Specifications

General

Brand	Linhai
Model	Mini 80
Category	Offroad Vehicle
Language	English