CHAPTER 3A ENGINE 260/ 300 / 400 cc ATV SERVICE MANUAL09.0
CHAPTER 3 ENGINE PAGE. 3A- 18
Handling notes for coolant:
Coolant is potentially harmful and should be
handled with special care.
WARNING:
splashes in your eyes:
Thoroughly wash your eyes with water and
consult a doctor.
If coolant splashes on your clothes:
zQuickly wash it away with water and then with
soap and water.
If coolant is swallowed:
Vomit immediately and see a physician.
CAUTION:
zHard water or salt water is harmful to engine
parts. Use only distilled water if soft water is not
available.
zIf you use tap water, make sure it is soft water.
zDo not use water containing impurities or oil.
zTake care that no coolant splashes onto
painted surfaces. If it does, wash them
immediately with water.
zDo not mix different types of ethylene glycol
antifreeze containing corrosion inhibitors for
aluminum engines.
9. Tighten:
zHose
Fill the coolant slowly to the specified level.
10. Install:
zRadiator cap
11. Start the engine and let it warm up for
several minutes.
12. Stop the engine and inspect the level.
NOTE:
Wait a few minutes until the coolant settles
before inspecting the coolant level.
13. Install: Remain parts.
To Next Page
Loading...
Need help?
General
