Technical Information
73
DGC 6xxx
2.6.4 Descaling
2.6.4.1 Descaling
The Descaling program is required to descale the steam generator. The
Descaling program is finished after 60 minutes. During the descaling cycle
the automatic altitude compensation process is also carried out so that the
appliance always operates with the correct temperature regardless of the
altitude of its installation site.
2.6.4.2 Descaling Cycle
Add a descaling tablet to the water container.
The contact time in the water tank is 60 seconds.
The steam generator is filled. The minimum fill time is 20 seconds.
This time may be extended if the level control sensor does not detect
water.
The steam generator is filled again for 35 seconds. During this time, water
flows into the cabinet.
Each heater element is activated for 20 seconds, one after the other.
The contact time is 60 seconds.
The steam generator is emptied and the release element closes the
steam generator again - Duration 125 seconds.
After 5 repeat cycles starting with filling of the steam generator, the steam
generator is emptied again and the release element closes.
The descaling cycle has now finished and the Rinse program is carried out.
After the rinse cycle, the altitude compensation process is carried out.
2.7 Machine Response after a Power Failure
After a power failure, any process in operation is cancelled and the fascia is
always lowered.
2.8 Wireless Roast Probe
2.8.1 Components
To Next Page
Loading...
Need help?
General
