4 - 36 Operator’s Manual
4 Setup
eGateway Query
To add an eGateway service
1. Set the eGateway server properties as described above.
2. Tap [Add] to add the service to the service list.
To modify a network service
1. Select the service to be updated in the service list.
2. Modify the parameters in the upper part of the screen and tap [Update] to update the setting.
eGateway Store
Before using the eGateway storage, ensure the Send Mode is set to “MDM with Reference” in the
eGateway Server configuration interface.
Item Description
Service Name The name of the eGateway service.
IP Address Input the ADT Source IP address in the eGateway Server configuration
interface.
Port Input the MAQ Server Port in the eGateway Server configuration
interface.
Clear Click to cancel the parameter setting.
Add Click to add the Network service to the service list.
Update Select an item in the service list, change the parameters in the above
area, and click [Update] to update the item in the service list.
Delete Click to delete the selected service in the service list
Default Set the eGateway server as the default.
Select an item in the service list, click [Default] and you can see “Y” in
the Default column.
Connect Click to verify whether the connection is normal.
Type Item Description
Configure Service Service Name The name of the eGateway service.
MultiBackend IP Address Input the ADT Source IP address in the eGateway
Server configuration interface.
Port /
DocServer IP Address Input the ADT Source IP address in the eGateway
Server configuration interface.
Port Input the Document Sharing SSL Port in the
eGateway Server configuration interface.
Image/Cine/PDF
Report
Set the shared document content.
To Next Page
Loading...
Need help?
General
