Operator’s Manual 14 - 1
14
DVR Recording
Strictly observe the procedures described here to perform the recording and replaying operations;
otherwise it may result in data loss or system malfunction.
The system provides built-in DVR recording function. You can use the DVR to record and replay
videos and audios that can be stored in DVD disc or hard disc.
The recorded video is AVI format; you can save it in the hard disk drive, burn to the DVD or export
to the USB disk.
When the built-in DVR is in normal status, the icon is displayed in the system tool bar menu.
14.1 Start Recording
After recording, the system will save the recording file automatically, you can select to save in local
disk, U disk or optical disk.
Perform the following procedure:
1. Perform ultrasound exams, select appropriate views and adjust parameters to prepare for
recording.
2. Tap to open the dialog box and select desired recording type.
3. Tap [Close] to enter recording status.
4. Press the user-defined key for “DVR” and tap [OK] to start recording, and the DVR icon
displays as in recording status.
During the recording process, you can perform imaging mode switching, comments adding,
body mark adding and measurements.
5. Press the user-defined key for “DVR” again to stop recording, the DVR icon in the lower right
corner turns into data transfer status .
– If USB/CDROM is selected, the system sends the recorded file to the target storage media
(USB disk or DVD optical disk drive) in the meantime.
– If Hard disk is selected, the system saves the file to the path: D:\TEX\DVR.
In the patient task management screen, tap [Media Storage Task] tab to check transferring
status.
14.2 Sending Image
The system also supports exporting recorded images that are saved in the local disk.
Perform the following procedure:
1. Tap to open the dialog box, and tap [Local Video Management] to enter the managing
dialog box.
Tap [Rename] to rename the video file.
To Next Page
Loading...
Need help?
General
