Mindray TEX20 Operator's Manual

4 Setup
Operator’s Manual 4 - 21
Descriptions of the attributes are shown in the following table.
b. Tap [OK] to confirm the setting.
7. Select the measurement sequence.
– [Repeat]: after the current measurement is completed, the system automatically activates
– the current tool again.
– [Next]: after the current measurement is completed, the system automatically activates the
next tool in the menu.
– [None]: after the current measurement is completed, the cursor returns to the end point of
the caliper.
8. Tap [Save] to confirm.
4.3.2 Application Measurement Preset
Measurement Package Preset
During measurement, the preset package displays on the touch screen. Items in the package can be
preset and may belong to different application regions.
You may configure more than one measurement package for current exam mode. Under actual
measurement status, switch the measurement library if necessary (by select the drop-down list in
the Advanced 2D page).
Select [Advanced] to enter the Add New Package.
• Creating Packages: Select [New] and enter a name for the new package in the dialog box pop-
up. Select [OK] to confirm. The new package displays in the [Selected Items] list.
• Deleting Packages: Select a package from the [Available Items] list and select [Delete].
• Setting Default Packages: Select a package from the [Selected Items] list, then click [Default].
The default package is marked with a √.
• Adjusting Package Positions: Select a package from the [Selected Items] and select [Move
Up]/[Move Down] to adjust the sequence that the packages in the menu are arranged in.
Measurement Menu Preset
The following operations are available.
Attributes Descriptions
Item Name & Result Results obtained from D trace are listed. The selected items will be
displayed in the results window after measurement.
• If PV is selected, other results become deselected.
• Some results, such as PS and ED, can be derived via a simple
method, but others, such as TAMAX, can only be derived via
complicated methods such as Manual, Spline, Auto, etc.
Methods for obtaining PS and TAMAX simultaneously (trace, spline
and auto) should be chosen if both PS and TAMAX are selected
(TAMEAN should use auto method).
Unit Select the measurement unit shown in result window and report.
Tap “Unit” column of each item to select.
CalcMethod Select the calculation method for the tool. The selected calculation tool
influences only the final result on the report.
Tap “CalcMethod” column of each item to select.

Mindray TEX20 Specifications

General

Brand	Mindray
Model	TEX20
Category	Diagnostic Equipment
Language	English