15 System Maintenance
Operator’s Manual 15 - 3
Cleaning the dust-proof cover
Please clean all the system’s dustproof covers periodically (once per month).
Failure to do so may result in system damage. Cleaning times can be
increased when the system is used in the open air or somewhere more dusty.
Perform the following procedure:
1. Press the clip of the dust-proof cover and unfold it outwards (shown in the figure below).
2. Clean the dust-proof mesh with water or soft brush.
Cleaning the ECG cable
Perform the following procedure:
1. Wipe the cable with a cotton ball or soft cloth moistened with water.
2. Use another soft dry cloth to remove any moisture and allow the cable to completely air dry.
15.1.2 Cleaning the peripherals
Do the cleaning maintenance according to your actual peripheral configuration; items which are not
configured can be skipped.
Content Description
Color and B/W video
printer
First wipe off dust or stain attached to the cover of printer with soft dry
cloth, then clean the inside of printer. Be sure to do the cleaning
maintenance according to the operation manual if necessary.
Graph / text printer First wipe off dust or stain attached to the cover of printer with soft dry
cloth, then clean the inside of printer. Be sure to do the cleaning
maintenance according to the operation manual if necessary.
Footswitch Use soft dry cloth with a little mild soap water to wipe off the dust or
stain attached to the pedals or cable of foot switch.
Barcode reader First use soft dry cloth to wipe off dust attached to glass panel of the
reader, then the dust or strain attached to cable and bracket.
To Next Page
Loading...
Need help?
General
