11 - 6 Operator’s Manual
11 Patient Data Management
2. Select operations:
– Click [Restore Items] to restore the item back to iStation.
– Click [Delete] to delete the item permanently, and the item can never be restored again;
– Click [Restore All Items] to restore all the items back to iStation;
– Click [Empty Recycle Bin] to empty the recycle bin and all items can never be restored
again.
– Click [Exit] to exit the recycle bin.
To set maximum number of days for deleted data to be kept in the recycle bin
The patient exams which exceed the preset maximum will be deleted and unrecoverable, it is
recommended to perform patient data backup before enabling this function to avoid data loss.
Perform the following procedure:
1. Input the desired number besides “Maximum number of days to be kept”.
If the input box is left blank, the feature will not be enabled.
Only the whole number ranging from 1 to 365 can be input.
2. Tap [Modify].
11.5 iStorage
To use iStorage function, you need UltraAssist software in 2.0 version (with V1.0 network
protocol); consult Mindray service engineer for details.
Network storage is used to save image files and measurement reports to the remote PC server.
For network storage setting, see the Setup chapter.
Perform the following procedure:
1. Enter iStation, select one (or more than one) patient data or image in the local data source.
2. Tap [Send To].
3. Select [iStorage] in the Send To dialog box, and select the PC server of the right side.
4. Select PC transfer format and check whether to send report.
5. Tap [Send] to start sending.
11.6 Print
For printer connection, see the System Preparation chapter.
For details about printer selection and print service setting, see the Setup chapter.
11.6.1 Image Printing
For DICOM image printing, refer to relevant chapters. Video printer is applied in image print
service.
To Next Page
Loading...
Need help?
General
