To Next Page

To Previous Page

15 - 2 Operator’s Manual

15 System Maintenance

Cleaning probes

Tools: mild soapy water, dry soft cloth, soft brush

Method:

1. Wipe out the dust attached to surface of probe head, connector and cable.

2. Use soft brush to brush the dust inside probe connector gently.

3. Remained stain or dust attached to surface of cable or surface of connector should be washed

out by cloth with a little soapy water, and then air-dry.

NOTE:

Don’t use cloth with water to clean the probe connector.

Cleaning holders

Tools: soft dry cloth, soapy water, soft brush.

Remaining stains should be wiped away using a cloth with clean or soapy water and the surface left

to air dry.

Perform the following procedure:

1. Use a soft dry cloth to wipe away dust attached to the inside, outside and gaps in the probe

holder. Use a soft brush to brush away dust or stains from the small intra-cavity probe holder or

its gap.

2. Remaining stains on the inside and outside of the holder should be wiped away using a cloth

with a little soapy water and then air dried.

Cleaning the display

NOTE:

Do not use chemical solvents, acid or alkaline solution to clean the display.

The ultrasound system has passed puncture test and leakage current test, and thus can be cleaned on

power-on status.

Tools: soft dry cloth, clean water or neutral detergent.

Clean the system in power off status; or in power on status, tap and select [Screen Lock] to

lock the system for 10 seconds.

Clean the display surface with a soft dry cloth. Remaining stains should be wiped away using a

cloth with a little neutral detergent or clean water and then leave to air dry.

Cleaning the cover

Tools: soft dry cloth, soapy water

Use a soft dry cloth to clean the system’s cover. If the system is dirty, moisten the soft cloth with

neutral soapy water, wipe away any stains, and dry the system in the air.

NOTE:

Use a soft brush to brush away dust attached to all visible sockets or interfaces (such as probe

sockets, sockets or interfaces in the IO panel and power supply panel). Do not use a cloth and water.

Mindray TEX20 Operator's Manual

Other manuals for Mindray TEX20