1 - 2 Operator’s Manual
1 Important Information
• For the connection of power and grounding, follow the appropriate
procedures described in this operator's manual. Otherwise, there is risk of
electric shock. Do not connect the grounding cable to a gas pipe or water
pipe; otherwise, improper grounding may result or a gas explosion may
occur.
• Before cleaning the system, disconnect the power cord from the outlet.
System failure and electric shock may result.
• This system is not water-proof designed. Do Not use this system in any
place where water or any liquid leakage may occur. If any water is sprayed
on or into the system, electric shock may result or the system may be
damaged. If water is accidentally sprayed on or into the system, contact
Mindray Customer Service Department or sales representative.
• DO NOT use a probe that has a damaged, scratched surface, or exposed
wiring of any kind. Immediately stop using the probe and contact Mindray
Customer Service Department or sales representative. There is risk of
electric shock if using a damaged or scratched transducer.
• Do not allow the patient to contact the live parts of the ultrasound system or
other devices, e.g. signal I/O ports. Electric shock may occur.
• The operator SHOULD NOT touch Signal Input Ports/Signal Output Ports
and the patient at the same time.
• Do not use an aftermarket probe other than those specified by Mindray.
The probes may damage the system causing a profound failure, e.g. a fire
in the worst case.
• Do not subject the transducers to knocks or drops. Use of a defective
transducer may cause an electric shock.
• Do not open the covers and front panel of the system. Short circuit or
electric shock may result when the system hardware is exposed and
powered on.
• Do not use the system with the patient when the system is being serviced
or maintained.
• Do not use this system when any digital device such as a high-frequency
electrotome, high-frequency therapeutic device or defibrillator is applied
already. Otherwise, there is a risk of electric shock to the patient.
• Only use the ECG leads provided with the physiology module; otherwise,
electric shock may be resulted.
• When moving the system, disconnect the system from other devices
(including probes) and disconnect the system from the power supply.
• The auxiliary power output outlet in the system is used to supply power for
the recommended peripheral devices. Do not connect other devices to the
outlet, otherwise, the rated output power may be exceeded and failure may
be resulted.
• Accessory equipment (analog or digital) connected to the ultrasound
system must comply with the relevant IEC standards (e.g., IEC 60950
information technology equipment safety standard and IEC 60601-1
medical equipment standard). Furthermore, all configurations must comply
To Next Page
Loading...
Need help?
General
