Tektronix TG8000 User Manual

Operating basics
IP ADDRESS. Set
s the IP address of the TG8000. When no value is set, the
default value is used. If D HCP service is enabled, the IP address obtained from
the DHCP server is used instead of the address entered here. Refer to Manually
Setting a Network Address below for instructions on how to enter an address.
NOTE. If you enter blank characters for the IP address, the network function of
the TG8000 becomes invalid.
SUBNET MASK. Sets the subnet address of the TG8000. When no value is set, the
default value is used. If DHCP service is enabled, the subnet address obtained
fromtheDHCPserverisusedinsteadof the address entered here. Refer to
Manually Setting a Network Address below for instructions on how to enter an
address.
GATEWAY ADDR. Sets the gateway address of the TG8000. Refer to Manually
Setting a Network Address below for instructions on how to enter an address.
Manually setting a network address. Use the following procedure to manually
enter
a network address:
1. Press the ENTER button to enter the edit mode to input the address.
2. Use the left (◄)orright(►) arrow button to move the underscore character
( _ ), and use the up (▲)ordown(▼) arrow button to enter the address value.
3. After you enter the address value, press the ENTER button to enable the
address.
2–40 TG8000 Multiformat Test Signal Generator User Manual

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English