Tektronix TG8000 User Manual

HD3G7 HD 3 Gb/s SDI Video Generator module
HD3G7 module z
one plate dependent parameters
Below the pattern control parameter in each of the parameter menus a re the
dependent parameters. The dependent parameters are the same for all the zone
plate patter
ns. Use the up (▲)ordown(▼) arrow button to scroll through the
parameter menu. If desired, use the left (◄)orright(►) arrow button to change
the parameter.
NOTE. Press the left (◄) and right (►) arrow buttons at the same time to reset
any parameter to its default value.
If you adjust any one of the dependent parameters individually, the pattern control
parameter will become invalid, and you will see this message:
The zone plate dependent parameters are discussed here, in the order in which
they a
ppear b elow the pattern control parameter, w hen usi ng the down (▼) arrow
button to scroll through the parameter m enu. The Custom–1 and Custom–2 signal
selections do not have pattern control parameters, and start with the Zone Plate
Amplitude Parameter.
Zone plate amplitude
parameter
Display name: ZP Amplitude
Uni
ts: mV
Use this parameter to adjust the zone plate signal amplitude from 0.0 mV to
79
8.0 mV, in 0.5 mV increments. The default value is 700 mV.
TG8000 Multiformat Test Signal Generator User Manual 3–177

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English