Tektronix TG8000 User Manual

AGL7 Analog Genlock module
AGL7 module ma
in menu
Use the AGL7 module main menu to select the genlock source and the output
whose parameters are to be change d.
Use the up (▲
)ordown(▼) arrow button to scroll through the main menu. The
following figure shows the AGL7 module main menu.
Figure 3-4: AGL7 module main menu
STATU
S. Displays the genlock source and status. The following status messages
may appear: Locked, Loss of Lock,andNo signal.
GENLOCK. Selects the genlock source and sets the timing offset of the genlock
signal relative to the internal reference signal. When you select this menu item
and press the ENTER button, you will access the GENLOCK submenu. (See
pa
ge 3-10.)
SELECT OUTPUT. Selects the output for you to change the signal format, output
signal, and timing offset relative to the internal reference signal (frame reset
signal). Use the left (◄) or r ight (►)arrowbuttontoselectBLACK 1, BLACK
2,orBLACK 3. When you select any of these and press the ENTER button, you
will access the OUTPUT submenu to set the parameters of the selected output.
(See page 3-12.)
TG8000 Multiformat Test Signal Generator User Manual 3–9

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English