USER’S MANUAL__________________________________________________________________
322 _________________________________________________________________ M211322EN-D
7.20 Pass Auxiliary Arguments to Opcodes
(XARGS)
This command provides a backward compatible mechanism for supplying
additional (optional) arguments to other opcodes. The command may be
used freely in the RVP900 instruction stream, even if the opcode being
modified does not expect any optional arguments. XARGS will be a NOP
in that case.
To supply optional arguments to another opcode "OP", the XARGS
command is first executed with the additional argument count encoded in
9 Reserved (was LOG clutter filter coefficients)
10 Range mask spacing in cm for each pulse width
11 Current value of UIQ bits from Set/Clr all prior operations
12 Individual threshold configuration for each data type. This
allows read back of the threshold table set with the THRESH
command (Section 7.29 Set Individual Thresholds (THRESH)
on page 329). Outputs 7 words per data type. Datatypes in the
order specified in the selection mask.
13 Extended parameter information defined in struct
dspExParmIO.
14 Minimum and maximum values of the optional I/O-62 A/D
converter, sampled over at least one complete pulse period.
Sixteen bit signed outputs represent the full range of the A/D
converter. When the RVP98D backpanel is connected, the first
Min/Max pair samples the LOGVideo input, the second pair
samples the CathodePulse input, and the third and fourth pairs
sample internal levels.
15 Returns an array of struct RVP9SpecFiltIO structures for each
of the non-zero clutter filter definitions, beginning with #1.
This is the same format used by the LFSPECS command to
define each individual clutter filter. The order is as defined in
the PPRMS_N_* #defines in rvp9.h.
16 Returns the identifiers of the currently active HydroClass
classifier algorithms. The identifiers are encoded in
sig_data_types.h
17 Returns the nickname of the currently active HydroClass
configuration. The nickname can be used to label the possible
customizations made to echo identification settings in the
dpolapp_*-band.conf file. It is impractical to save all
modified parameters as metadata. The string of 16 characters
is reported in a sequence of eight words, each reporting two
characters.
To Next Page
Loading...
Need help?
General