USER’S MANUAL__________________________________________________________________
378 _________________________________________________________________ M211322EN-D
C.13 Setup "Mz" Command (Transmitter Phase
Control)
Test Goal
Verify that the TTY setups for the Transmitter Phase Control section are
properly configured for the customer application. This feature is not used
for magnetron systems since these have inherent random phase that is
measured, but not controlled.
Special Test Equipment
- KVM connected
Reference
- See Section 4.2.8 Mz — Transmissions and Modulations on page 137.
Test Procedure
1. Enter the TTY setups and type the "Mz" command.
2. Set all the values as required.
Test Passed
Parameters set.
For Customer_________________________________ Date__________
For Vaisala___________________________________ Date__________
To Next Page
Loading...
Need help?
General