Appendix B _______________________________________________________ RVP900 Packaging
VAISALA______________________________________________________________________ 349
APPENDIX B
RVP900 PACKAGING
This section describes the general features of the packaging and the
electrical specifications and cabling of these units.
B.1 RVP900 Processor Components
A complete RVP900 processor is built from the following components:
- RVP902 Main Computer (see TBD)
- RVP901 IFDR Module (IF Digital Receiver) (see Section B.4 IFDR
Module on page 344)
- Optional DAFC (Digital AFC) (see Section B.5 Optional DAFC on
page 347)
- Optional TDWR Custom Back Panel (see TBD)
B.2 Safety
Read CAREFULLY the following warnings before you apply power to
your system.
WARNING
The main chassis power supply modules are NOT auto ranging. These
must be set by a switch on each module for either 115/230 VAC 60/50 Hz.
Verify these before applying power to the system.
WARNING
Turn off power to the main chassis before installing or removing any PCI
boards. For safety, the line cord should be disconnected before opening
either the IFD module or main chassis.
To Next Page
Loading...
Need help?
General