Vaisala RVP900 User Manual

Appendix C _____________________________________________ Installation and Test Procedures
VAISALA______________________________________________________________________ 377
C.12 Setup "M+" Command (Debug Options)
Test Goal
Verify that the TTY setups for the Debug Options section are properly
configured for the customer application.
Background
The RVP900 supports several test features that are configured in this
section. For operational systems, the simulation features should be turned
off. Vaisala recommends that the LEDs be set to "1:Go/Proc" so that the
front panel red LED flashes during each processing cycle.
Special Test Equipment
- KVM connected
Reference
-See Section 4.2.7 M+ — Debug Options on page 136
Test Procedure
1. Enter the TTY setups and type the "M+" command.
2. Set all the values as required.
Test Passed

Parameters set.
For Customer_________________________________ Date__________
For Vaisala___________________________________ Date__________

Vaisala RVP900 Specifications

General

Brand	Vaisala
Model	RVP900
Category	Receiver
Language	English