USER’S MANUAL__________________________________________________________________
476 _________________________________________________________________ M211322EN-D
To make sure you are not delivering high static voltages yourself:
- Avoid touching exposed connectors unnecessarily.
- Handle ESD sensitive components on a properly grounded and
protected ESD workbench.
- When an ESD workbench is not available, ground yourself to the
equipment chassis with a wrist strap and a resistive connection cord.
- If you are unable to take either of the above precautions, touch a
conductive part of the equipment chassis with your other hand before
touching ESD sensitive components.
- Always hold the boards by the edges and avoid touching the
component contacts.
G.3 Regulatory Compliances
This equipment complies with the standard listed in Table 34.
G.3.1 DC Power Conditions for Use
These conditions must be met by the customer installation for the unit to
be considered safe in DC power application:
- DC power as rated on the label or in the manual; 24V 4V
- Operating Temperatures:
- RVP901-WSP components are rated for -20°C to 55°C
- RVP902 processor rated for 10°C to 35°C
- RCP903 components are rated for -20°C to 55°C with the
exception of the RS-422 Receivers, which are limited to 0°C to
55°C. Part was specified to maintain full compatibility with
original design. Receivers are expected to operate down to -20°C,
but it is not guaranteed by design.
- If not listed specifically above, components are rated for a
minimum of -20°C to 55°C operating temperature
Table 34 Regulatory Compliances
Listing Standard
Electrical Safety
CE Mark EN60950-1
EMC 61000:
US EMC FCC part 15, subpart B, Class A, EN55011
EU: Emissions IEC6100-6-2 EMC Emissions
EU: Immunity IEC6100-6-4 EMC Immunity Testing
To Next Page
Loading...
Need help?
General