7.10 Peripheral Devices and Options
548 YASKAWA SIEPYAIH6B01A HV600 AC Drive Bypass Technical Reference
7.10 Peripheral Devices and Options
â—† Bypass Communication Options
There are many available peripheral devices and options for the bypass.
Refer to the HV600 catalog (CA.HV600.01) for information about available options, including:
• Main circuit options
• Frequency settings and monitor options
• Keypad options
• Attachment options
• Engineering tools
Contact Yaskawa or your nearest sales representative to make an order.
Refer to the instruction manual for each option for wiring information.
â—† Tools Required for Option Installation
• A Phillips screwdriver (M3 metric or #1, #2 U.S. standard) to install the option and remove the bypass front cover.
Screw sizes vary by capacity. Select a screwdriver appropriate for the capacity.
Note:
Use a short-shaft, magnetic screwdriver when installing the option card into the narrow enclosure models H6BPD002 to D074 and B001 to
B077.
• A straight-edge screwdriver (blade depth: 0.4 mm, width: 2.5 mm) to wire the option terminal block when installing
the SI-W3 LonWorks option.
Note:
This manual does not list the tools required to prepare the option cables for wiring.
â—† Bypass Options
These configurations are available for the bypass:
â– Option B
Three-contactor bypass: Isolates the drive circuit by adding a separate drive input contactor.
â– Option D
Ethernet/IP option.
â– Option G
Drive Input Disconnect Switch: Provides a disconnect means for the input side of the Drive, for Drive isolation
capability during bypass operation. This disconnect is located inside the enclosure with an integral operating handle.
â– Option L
Serial Communication, Echelon LonWorks: An isolated circuit board provides LonTalk protocol for network
communication to a BAS. This option plugs into the CN5 connection on the bypass control circuit board.
â– Option M
Lockable Circuit Breaker SCCR panel rating of 100 kA (no external customer fuses or internal fuses are necessary)
â– Option W
Custom Nameplate: Provides a custom nameplate for placement on the front of the bypass.
To Next Page
Loading...
Need help?
General