$GYDQW
&RQWUROOHU8VHU¶V*XLGH
6HFWLRQ 2SHUDWRU ¶V,QWHUIDFH
3BSE 002 415R701 Rev A 1-103
9DULDEOH6SHHG'ULYH&RQWURO
Variable-speed motor drives can be directly connected to Advant Controller 450 via a
specialized interface board that resides in the controller. The board contains a pulse counter for
accurate rotational-speed measurement and outputs a compensation signal to an analog
converter. The accuracy normally associated with digital drives only is also made available to
analog drives. The board exchanges setpoints, measured values, start and stop commands and
indications with the drive controller.
&HQWUDO2SHUDWRU6WDWLRQ6XSSRUW$GYD&RPPDQG0DVWHU9LHZ
Using a central operator station, for example Advant Station 500 Series or MasterView 800/1
Series, provides a powerful operator interface to the process control. For further information,
see the appropriate operator station documentation.
The main areas of support from Advant Controller 450 are summarized as follows:
• Object data base
• Alarm and events
• Group Alarm
•Reports
• Trend Data Storage
• Status List
• System Status List.
2SHUDWRU¶V,QWHUIDFH
Advant Controller 450 offers a range of interfaces to operators of different categories. A short
presentation is given below. For detailed information, see separate documentation.
0DLQWHQDQFH3HUVRQQHO
The main purpose of this type of interface is to support fault tracing and backup handling of the
application program. There are:
• Start mode selector, LED indicators and character display on the processor module
• Diagnostics LED indicators on most hardware modules
• Configuration tool setup for fault tracing and backup handling.
Otherwise, the normal use of a configuration tool is to configure the controller. It would
also be used to adjust and change the application in a level not reachable from an operator
station.
To Next Page
Loading...
Need help?
General
