EasyManuals Logo
Home>ABB>Controller>Advant Controller 450

ABB Advant Controller 450 User Manual

ABB Advant Controller 450
564 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #327 background imageLoading...
Page #327 background image
Advant
®
Controller 450 User’s Guide
Section 4.1.5 Relations between Start Modes and Working Modes
3BSE 002 415R701 Rev A 4-5
4.1.5.1 First Power-up
Additional Information for Redundant Processor Modules
Please find above information relevant to the primary unit.
Normally the backup unit has the same start mode selector setting.
Set 3 (CLEAR) on both processor modules, then the left module is PRIMARY.
Resulting working modes:
PRIMARY P2 CONFIGURATION
BACKUP Start in b2 UPGRADING and then transition to b1 STANDBY
Figure 4-2. First Power-up
Starting-point: Uninitialized controller, for example
Event : Power-up
Start mode selector:
Actions executed
by the controller
Resulting
working mode
newly delivered controller, or controller without memory backup voltage.
- Install system
SW
- Clear applic.
area
OPERATION
P1
STOPPED
-3
OFFLINE
-4
(Compulsory
setting)
2
3
4
(AUTO) 1
2
3
4
1
(CLEAR)
2
3
4
1
(STOP)
3
1
(OFFLINE)
2
3
4
CONFIG.
P2

Table of Contents

Other manuals for ABB Advant Controller 450

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB Advant Controller 450 and is the answer not in the manual?

ABB Advant Controller 450 Specifications

General IconGeneral
BrandABB
ModelAdvant Controller 450
CategoryController
LanguageEnglish

Related product manuals