ABB Advant Controller 450 User Manual

$GYDQW

&RQWUROOHU8VHU¶V*XLGH
6HFWLRQ 3URGXFW2YHUYLHZ
3BSE 002 415R701 Rev A 1-17
The system can handle thousands of inputs and outputs, connected directly or remotely to the
controller. Distributed I/O units, PLC-type controllers (Programmable Logic Controller) and
converters for d.c. motor drives can be connected via a field bus. Interface is available to other
vendors’ systems.
Measured values can be logged and/or tied to alarm and event registration.
Depending on the number of input and output channels, several equipment frames (subracks)
may be required to accommodate an Advant Controller 450 system. These subracks are installed
in one cabinet or several cabinets.
You can include an Advant Controller 450 in a network with other ABB Master products, for
example other Advant Controllers and products from the Advant Station 100 Series, the Advant
Station 500 Series and the Advant Station 800 Series. These series include operator stations,
information management systems (IMS) and engineering stations. From a compatibility
viewpoint, you can also include MasterPiece 200/1 products, MasterView 800/1 products,
SuperView 900 products and external computers in the network (see Figure 1-1).
You can connect a local operator station and a printer to an Advant Controller 450 via standard
serial channels.
)LJXUH  $GYDQW&RQWUROOHULQ 50 &DELQHWGRRUVRSHQ HG
([DPSOHRI3K\VLFDO$SSHD UDQFH

ABB Advant Controller 450 Specifications

General

Brand	ABB
Model	Advant Controller 450
Category	Controller
Language	English