2-72
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
CWANLC Messages
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %CWAN_HA-4-SRPSYNC: Slot [dec]: [chars]
Explanation
The specified error occurred while synchronizing the SRP states from the active
supervisor engine RP to the redundant supervisor engine RP.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
CWANLC Messages
This section contains Catalyst 6500 series switch and Cisco 7600 series router WAN module (CWANLC)
messages.
CWANLC-3
Error Message %CWANLC-3-FPD_INCOMPATIBLE: FPD ID=[int] image in this FPD package is
for revision [int].x boards. It is incompatible with current board revision of
[int].[int]
Explanation
This FPD package does not contain images that are compatible with the current line card
revision.
Recommended Action Perform the FPD upgrade operation with a newer version of an FPD image
package that is compatible with the Cisco IOS software that is operating on the switch. Consult with
the FPD image package section of the Cisco IOS software release note to confirm that your line card
revision is supported for a particular release.
To Next Page
Loading...
Need help?
General