2-179
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
MMLS_RATE Messages
Error Message %MMLS-6-VLAN_ADD_FAILURE_ON_MET_FULL: Error adding vlan [dec] to the
MET table of some shortcuts
Explanation
The MET is full. The system is unable to add the specified VLAN to some shortcuts.
The affected shortcuts will not switch traffic for that VLAN.
Recommended Action The MET utilization is very high and needs to be brought down by removing
some VLANs or switching to ingress replication mode.
MMLS_RATE Messages
This section contains Multicast Multilayer Switching Rate Limiting (MMLS_RATE) messages.
MMLS_RATE-3
Error Message %MMLS_RATE-3-MMLS_PARTIAL_SC_ERROR: Error installing Multicast
Partial-sc rate-limiter.Operation failed.
Explanation
The multicast partial-sc rate limiter could not be configured because of an error that was
returned from the switch processor.
Recommended Action The LTL index for the partial-sc rate limiter might not have initialized yet. Wait
several minutes, and try to configure the rate limiter again.
MRIB_PROXY Messages
This section contains Multicast Routing Information Base proxy (MRIB_PROXY) messages.
MRIB_PROXY-2
Error Message %MRIB_PROXY-2-MRIB_LC_CREPRC_FAILED: LC in slot [dec] failed to create
a required process.
Explanation
The line card could not create a process to perform delayed IPC initialization. The
MFIB will not be started on this line card.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General