2-156
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
L2 Messages
Error Message %KEYMAN-4-KEYSTR_CRYPTO_TYPE: Type [dec] encryption unknown.
Interpreting keystring as literal
Explanation
The system does not recognize the format type. A key string format type value of 0
(unencrypted key string) or 7 (hidden key string), followed by a space, can precede the actual key
string to indicate its format. An unknown type value will be accepted, but the system will consider
the key string as being unencrypted.
Recommended Action Use the correct format for the value type or remove the space following the
value type.
L2 Messages
This section contains Layer 2 (L2) messages
Error Message %L2-3-DUP_REG: L2 Forwarding Engine: [chars] Attempt to program
duplicate MAC address
Explanation
There was an attempt to program a duplicate MAC address in the match registers.
[chars] indicates the source of the attempt.
Recommended Action Copy the error message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error using the Output Interpreter
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Issue the show tech-support
command to gather data that may help identify the nature of the error. Also perform a search of the
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance,
open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
L2_AGING Messages
This section contains Layer 2 aging (L2_AGING) messages.
L2_AGING-2
Error Message %L2_AGING-2-DEC_EN_FAIL: Failed to initialize Distributed EtherChannel
Explanation
One or more resources that are required for the Distributed EtherChannel operation are
in use.
Recommended Action Remove the monitor session reserved for service modules by entering the no
monitor session service module command, and then try to reinitialize the operation.
To Next Page
Loading...
Need help?
General