2-27
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
C7600_SIP200 Messages
C7600_SIP200 Messages
This section contains SPA Interface Processor 200 (C7600_SIP200) messages.
C7600_SIP200-3
Error Message %C7600_SIP200-3-BADIFCTRL: Corrupted sip-200 information for interface
[chars] [[hex]]
Explanation
The interface SIP 200 information is not valid. An internal software error has occurred.
Recommended Action Copy the error message exactly as it appears on the console or in the system
log, collect the output of the show memory command on the line card, and contact your technical
support representative with the gathered information.
Error Message %C7600_SIP200-3-SONET_CLOCK_FAILED: SPA Sonet clock has failed (status
= [hex])
Explanation
The SPA SONET clock has failed. SPAs that rely on the SPA SONET clock for proper
operation, such as PoS and ATM, will be affected.
Recommended Action If the SPA SONET clock does not recover, perform an OIR.
Error Message %C7600_SIP200-3-SONET_CLOCK_RECOVERED: SPA Sonet clock has recovered
(status = [hex])
Explanation
SPA SONET clock has recovered.
Recommended Action No action is required.
C7600_SIP200-4
Error Message %C7600_SIP200-4-MEM_MODULE_MISMATCH: Memory modules are not identical
Explanation
The memory modules do not have identical parameters. This condition might impact
performance.
Recommended Action Copy the error message exactly as it appears on the console or in the system
log, collect the output of show memory command on the line card, and contact your technical
support representative with the gathered information.
C7600_SIP200_MP Messages
This section contains SIP 200 Multiprocessing (C7600_SIP200_MP) messages.
To Next Page
Loading...
Need help?
General