2-245
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
SSA Messages
Error Message %SPLITVLANM-6-NBAR_PD_ENABLED: Protocol Discovery accelerated on
[chars] direction of: [chars]
Explanation
NBAR protocol discovery is enabled, the feature is accelerated, and all traffic is directed
to the PISA.
Recommended Action No action is required. This message is for informational purposes only.
SSA Messages
This section contains Super Santa Ana ASIC (SSA) messages.
SSA-4
Error Message %SSA-4-FABRICCRCERRS: [dec] Fabric CRC error events in 100ms period
Explanation
The SSA fabric interface encountered more CRC error events than the supervisor engine
CRC error threshold allows.
Recommended Action The module has notified the supervisor engine, and the error has been logged.
No action is required.
Error Message %SSA-4-FABRICSYNCERRS: [dec] Fabric sync error events in 100ms period
Explanation
The SSA fabric interface encountered more synchronization error events than the
supervisor engine synchronization error threshold allows.
Recommended Action The module has notified the supervisor engine, and the fabric interface will be
resynchronized. No action is required.
SSA-5
Error Message %SSA-5-NOFABRICPROCESS: The Super Santa Ana fabric process could not
be created
Explanation
The SSA fabric interface does not have a link process running because the system failed
to create it. This module will not support the fabric interface.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
To Next Page
Loading...
Need help?
General