2-111
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
EARL_L2_ASIC Messages
EARL_DRV_API-4
Error Message %EARL_DRV_API-4-NOMEM: Malloc failed: [chars] [dec]
Explanation
The system is running out of memory.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
EARL_L2_ASIC Messages
This section contains Enhanced Address Recognition Logic Layer 2 ASIC (EARL_L2_ASIC) messages.
EARL_L2_ASIC-0
Error Message %EARL_L2_ASIC-0-EXCESSIVE_FT_TBL_ECC_ERR: EARL L2 ASIC [dec]: Too many
bad entries in L2 Forwarding Table
Explanation
The EARL Layer 2 ASIC detected too many errors in the forwarding table. This
condition indicates hardware malfunction and causes the system to reload.
Recommended Action If this problem is seen more than once, it could be a case of faulty hardware.
Copy the message exactly as it appears on the console or in the system log. Research and attempt to
resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With some
messages, these tools and utilities will supply clarifying information. Search for resolved software
issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require
assistance, open a case with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General