2-206
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
POSLC Messages
PM_SCP-4
Error Message %PM_SCP-4-FPOE_INFO: An unsupported distributed fabric card has been
detected
Explanation
Fabric-capable modules are not supported in this system.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %PM_SCP-4-UNSUPPORTED: Interface [chars] does not support receive-only
transceivers
Explanation
A receive-only transceiver has been inserted into a slot that does not support it.
Recommended Action Use the receive-only transceiver with a supported module.
POSLC Messages
This section contains Packet over SONET module (POSLC) messages.
POSLC-3
Error Message %POSLC-3-PROCESS_CREATEFAIL: [chars]
Explanation
The PoS module could not create a process required for its operation. This condition
might occur because a resource is unavailable.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General