2-43
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
C7600_SSC400 Messages
Error Message %C7600_SSC400-3-SINGLE_SPA_MODE: Module will use only bay [dec]. Bay
[dec] is shut.
Explanation
The 7600-SSC-400 is in single-SPA mode.
Recommended Action This message is informational only. No action is required.
Error Message %C7600_SSC400-3-SSC_BAY_SHUT: Bay [dec] is shutdown because
7600-SSC-400 is in single-spa-mode
Explanation
The specified bay is shut down. In single-SPA mode, only one bay is active.
Recommended Action Refer to the IPsec SPA documentation for information about single-SPA mode.
Error Message %C7600_SSC400-3-SW_ERROR: NULL
Explanation
A software error occurred.
Recommended Action Copy the error message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error using the Output Interpreter
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance,
open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
C7600_SSC400-7
Error Message %C7600_SSC400-7-DP_DISABLE: [chars] FPGA is forced disabled.
Explanation
This field-programmable gate array (FPGA) has been forced into a disabled state. This
is a debugging feature.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General