Name: Cisco III - Supervisor Engine III
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2-183

Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY

OL-11469-02

Chapter 2 Messages and Recovery Procedures

OIR Messages

NETWORK_RF_API-3

Error Message %NETWORK_RF_API-3-FAILDECODEDATADESCINSTDBY: Cannot decode data

descriptor in Standby for [chars], descriptor type=[dec]

Explanation

An internal data descriptor could not be decoded by the standby device. This message

identifies the interface or controller that caused the decoding failure in the standby device. This

interface was encoded in the active device but could not be decoded in the standby device. This

failure probably occurred because of a software error.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the issue using the tools and utilities provided at

http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying

information. Search for resolved software issues using the Bug Toolkit at

http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the

Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or

contact your Cisco technical support representative and provide the representative with the

information you have gathered. Attach the following information to your case in nonzipped,

plain-text (.txt) format: the output of the show logging and show tech-support commands and your

pertinent troubleshooting logs.

Error Message %NETWORK_RF_API-3-IPC: [chars] [chars]

Explanation

An IPC error occurred. Additional details on the nature of the error are specified in the

message text on the console or in the system log.