2-146
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
HA_EM Messages
HA_EM Messages
This section contains Embedded Event Manager (HA_EM) messages.
HA_EM-3
Error Message %HA_EM-3-FMPD_CLI_NOTTY: Error attempting to access an unopened CLI
session: [chars]
Explanation
An error occurred while the system attempted to access the specified unopened CLI
session.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
HYPERION Messages
This section contains Hyperion ASIC (HYPERION) messages.
HYPERION-3
Error Message %HYPERION-3-FAILURE_INTR_CFG: Failure to setup the Hyperion device
interrupts.
Explanation
The internal ASIC on a line card could not be initialized. The device is not operational
and has been disabled. The data path is not operational.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General