2-223
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
SIP600 Messages
Error Message %SIP400-2-PCI_ERROR_INT: A PCI Error interrupt occurred while trying
to access a device (status reg = [hex], addstatus reg = [hex])
Explanation
A PCI error interrupt occurred while trying to access a device.
Recommended Action If this message recurs, copy the message exactly as it appears on the console
or in the system log. Research and attempt to resolve the issue using the tools and utilities provided
at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
SIP600 Messages
This section contains SPA Interface Processor 600 (SIP600) messages.
SIP600-2
Error Message %SIP600-2-DEVMGR_ASIC_INIT_FAILED: SIP-600 ASIC Initialization failed
at stage-asic_init[dec]
Explanation
The SIP 600 received an error when attempting to initialize the ASICs that make up the
forwarding hardware. A hardware problem has prevented the SIP 600 from fully initializing on the
line card. Packets will not be forwarded.
Recommended Action Reload the line card. If the problem persists, copy the message exactly as it
appears on the console or in the system log. Research and attempt to resolve the issue using the tools
and utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities
will supply clarifying information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General