2-16
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
C6K_POWER Messages
C6K_PLATFORM-5
Error Message %C6K_PLATFORM-5-LESS_SPACE : May not have enough space to save the
crash info. on flash of [chars] on module: [dec]
Explanation
The flash memory device does not have enough memory to save the crash information.
It is possible that crash information could not be saved on the flash memory device.
Recommended Action Remove files from the flash memory device that may not be needed, and enter
the squeeze command for the flash memory device.
Error Message %C6K_PLATFORM-5-MISMATCH : '[chars]' device programming algorithm
mismatch detected on [chars] (module: [dec]), formatting is recommended.
Explanation
The flash memory device programming algorithm that was written to the device when
the flash memory was formatted is different from what the current running software has detected.
Recommended Action Reformat the flash memory device. Otherwise, no action is required.
C6K_POWER Messages
This section contains Catalyst 6500 series switch and Cisco 7600 series router power (C6K_POWER)
messages. For more power messages, see the “C6KPWR Messages” section of this chapter.
C6K_POWER-3
Error Message %C6K_POWER-3-NOTIFY_FAIL: Failed to notify RP of change in operator
status for [chars] number [dec] from ’[chars]’ to ’[chars]’
Explanation
The SP is unable to acquire the resources needed to notify the RP of the event specified
in the error message.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General