2-135
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
FABRIC Messages
Error Message %EPLD_STATUS_OPEN-4-ERROR_WRITE: %Error: status file [chars] write
failed
Explanation
An unknown error occurred while the system was writing the status program file to
nonvolatile memory.
Recommended Action Delete and recopy the file. If this message recurs, copy the message exactly as
it appears on the console or in the system log. Research and attempt to resolve the issue using the
tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and
utilities will supply clarifying information. Search for resolved software issues using the Bug
Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case
with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
FABRIC Messages
This section contains fabric (FABRIC) messages.
FABRIC-3
Error Message %FABRIC-3-LOST_SYNC: [chars] endpoint of fpoe:[dec] lost Sync. to
[chars] fabric,#[dec] times recovered success, trying to recover now!
Explanation
A fabric channel is reported to be out of synchronization. The system will attempt to
synchronize the channel now.
Recommended Action This message is informational only. No action is required.
FIB Messages
This section contains Forwarding Information Base (FIB) messages.
FIB-2
Error Message %FIB-2-FIBRETRY_EXCEEDED: CEF table download to slot [dec] not
performed as IPC port did not come up
Explanation
The FIB could not be fully downloaded. As a result of this condition, hardware
switching might not be functional on the module.
Recommended Action Reset the module to overcome this condition.
To Next Page
Loading...
Need help?
General