2-248
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
SSP Messages
SSP-4
Error Message %SSP-4-CANNOTRUNVER: SSP version [dec].[dec] was requested but is not
supported in this image.
Explanation
The version of SSP requested by the active device is not available in this image. SSP
will not run on this device until it is upgraded or the active device is downgraded.
Recommended Action Verify that all SSP peers are running compatible images and that the
configuration on each device is correct.
Error Message %SSP-4-GROUPCREATEFAIL: The SSP group could not be created.
Explanation
The maximum number of SSP groups has been reached. Only one SSP group is
permitted at one time.
Recommended Action No action is required.
Error Message %SSP-4-MISMATCHEDVERRECV: Wrong version on received packet.
Explanation
The SSP version information in a received packet does not match the version that is
currently running on this device.
Recommended Action Verify the configuration of all the SSP peers. Ensure that all peers are running
the correct image.
SSP-5
Error Message %SSP-5-DISABLED: SSP entering disabled state.
Explanation
The SSP has entered the disabled state. This condition is normal under many
circumstances. An example of a normal condition is when the SSP configuration is changed or when
a tracked interface is shut down or fails.
Recommended Action If this change occurred because of failure on the active peer, eliminate the
cause of failure and reload the failed device.
SSP-6
Error Message %SSP-6-ACTIVE: SSP entering active state.
Explanation
The SSP has entered the active state.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General