2-249
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
STAPL Messages
Error Message %SSP-6-IPREDGRPADD: An IP Redundancy group listed in the SSP config
has been added to this device.
Explanation
The device might now become the active device or the redundant device if no other
configuration items are missing.
Recommended Action No action is required.
Error Message %SSP-6-IPREDGRPDEL: An IP Redundancy group listed in the SSP config
has been removed from this device.
Explanation
The device might not become the active device or the redundant device if any
configuration items are missing.
Recommended Action Add the IP redundancy group to the device, or remove it from the SSP
configuration.
Error Message %SSP-6-STANDBY: SSP entering standby state.
Explanation
The SSP has entered standby state.
Recommended Action No action is required.
STAPL Messages
This section contains Standard Test and Programming Language (STAPL) messages.
STAPL-4
Error Message %STAPL_OPEN-4-ERROR_ALLOC: %Error: Can’t allocate [dec] bytes for
STAPL data
Explanation
The system could not allocate the required memory to access the file.
Recommended Action Check the memory usage of the system, and retry the operation.
Error Message %STAPL_OPEN-4-ERROR_OPEN: %Error: Can’t open [chars]
Explanation
The system is unable to open the file specified in the error message.
Recommended Action Ensure that the filename is correct. Enter the dir command to verify the
filename.
To Next Page
Loading...
Need help?
General