2-167
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
MFIB_CONST_RP Messages
MDT-4
Error Message %MDT-4-NO_GROUP_LINK: MDT entry [chars]:([IP_address],[IP_address])
linked by source but not linked by group
Explanation
The entry for the affected MDT group was not properly linked into the MDT database.
The inconsistency has been repaired. [chars] is the MDT entry and the [IP_address],[IP_address] are
the linked IP addresses.
Recommended Action No action is required.
Error Message %MDT-4-RD_CONFLICT: MDT entry [chars]:([IP_address],[IP_address])
received an update for RD [chars]
Explanation
A previously existing MDT entry should have been withdrawn by BGP before sending
this conflicting update. [chars] is the MDT entry, the [IP_address],[IP_address] are the linked IP
addresses, and the second [chars] is the redirect name.
Recommended Action Copy the error message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error using the Output Interpreter at
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the
Bug Toolkit at http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
MFIB_CONST_RP Messages
This section contains Multicast Forwarding Information Base route processor (MFIB_CONST_RP)
messages.
MFIB_CONST_RP-6
Error Message %MFIB_CONST_RP-6-REPLICATION_MODE_CHANGE: Replication Mode Change
Detected. Current system replication mode is [chars]
Explanation
When automatic detection of the replication mode is enabled, the system will transition
to ingress mode when an egress-incapable line card is inserted. The system will transition back to
egress mode when the last egress-incapable line card is removed. The transition between ingress and
egress modes will cause temporary loss of traffic,
Recommended Action To prevent traffic loss, enter the ipv6 mfib hardware-switching
replication-mode ingress command.
To Next Page
Loading...
Need help?
General