2-182
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
NETFLOW_AGGREGATION Messages
NETFLOW_AGGREGATION Messages
This section contains NetFlow Aggregation (NETFLOW_AGGREGATION) messages.
NETFLOW_AGGREGATION-3
Error Message %NETFLOW_AGGREGATION-3-FLOWMASK_CONFLICT: Netflow [chars] cannot set
the required flowmask
Explanation
The NetFlow aggregation flow mask conflicts with other features.
Recommended Action If NetFlow Data Export is configured, increase the size of the NDE flow mask
to VLAN full flow by entering the mls flow ip interface-full command, and then reconfigure the
NetFlow aggregation scheme. If this message recurs, copy the message exactly as it appears on the
console or in the system log. Research and attempt to resolve the issue using the tools and utilities
provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply
clarifying information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
NETFLOW_AGGREGATION-4
Error Message %NETFLOW_AGGREGATION-4-NO_TOS_AGGR: Disable hardware switching to
enable [chars]
Explanation
NetFlow does not currently support ToS-based aggregation schemes for
hardware-switched flows.
Recommended Action If ToS-based aggregation is required, disable hardware switching.
NETWORK_RF_API Messages
This section contains network redundancy feature API (NETWORK_RF_API) messages.
To Next Page
Loading...
Need help?
General