2-266
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
VPNSM Messages
VPN_HW-3
Error Message %VPN_HW-3-MULTDEV: Cannot support more than one Encryption AIM
Explanation
A second Encryption AIM was discovered present in the system. The Encryption AIM
software only supports a single Encryption AIM. All other Encryption AIMs installed will be
ignored.
Recommended Action Remove one of the Encryption AIMs that are installed in your system.
VPN_HW-6
Error Message %VPN_HW-6-INFO: slot: [dec] [chars]
Explanation
This is informational message from the VPN hardware accelerator driver.
Recommended Action This message occurs during normal system operation. No action is required.
Error Message %VPN_HW-6-SHUTDOWN: [chars] shutting down
Explanation
The specified VPN hardware is shutting down. It may have been physically removed.
Recommended Action This message occurs during normal system operation. No action is required.
VPNSM Messages
This section contains Virtual Private Network Services Module (VPNSM) messages.
VPNSM-3
Error Message %VPNSM-3-ACEI0BADPARAM: PcpManCreateTunn: cannot create tunnel with
expiring Sa
Explanation
An error has been reported by the firmware.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.