Cisco III - Supervisor Engine III User Manual

2-211
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
RF Messages
RF Messages
This sections contains redundancy feature (RF) messages.
RF-3
Error Message %RF-3-FAILED_SET_RED_MODE: ACTIVE failed to set redundancy mode.
STANDBY has selected mode but unable to get confirmation from ACTIVE.
Explanation
Under normal conditions, the standby route processor (RP) has selected the redundancy
mode and sends its decision to active RP. The active RP uses it to determine the system mode and
sends the final decision on the mode back to standby RP. This system message indicates that the
exchange has failed, and the standby RP does not have the right redundancy mode to proceed.
Recommended Action Allow the standby RP to reset once. If the problem persists, verify that all
modules are working properly.
Error Message %RF-3-NON_HA_SWITCHOVER: The SP switchover was NOT stateful. To
support SSO on the RP, the SP must be configured with HA enabled.
Explanation
The switch processor switchover that occurred was not stateful. Stateful switchover
mode on the route processor requires the switch processor to run with high availability (HA) enabled
to ensure that appropriate state is synchronized between the switch processors and that there is
sufficient state information on the new active switch processor to support the switchover of the route
processor while in stateful switchover mode. The recovery is to reset and reboot the route processor,
because there is insufficient state information to support a route processor switchover in stateful
switchover mode.
Recommended Action Configure the SP to enable HA. If HA is enabled, it is possible that resource
exhaustion (such as memory) might have caused this non-HA switchover. If the problem persists,
contact Cisco technical support representative for further analysis.
Error Message %RF-3-PEER_RP_RELOAD: The peer Route Processor (RP) is being reset
because [chars]
Explanation
This message provides the reason that the peer RP was reset. The peer RP resets in an
attempt to recover from an indeterminate state.
Recommended Action If the condition persists after the reset, copy the message exactly as it appears
on the console or in the system log. Research and attempt to resolve the issue using the tools and
utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities will
supply clarifying information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.

Cisco III - Supervisor Engine III Specifications

General

Brand	Cisco
Model	III - Supervisor Engine III
Category	Software
Language	English