2-55
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
CHKPT Messages
CHKPT Messages
This section contains checkpointing (CHKPT) messages.
CHKPT-3
Error Message %CHKPT-3-ILLEGAL: ILLEGAL call to CF API on ([chars]) by ([chars]).
Explanation
A severe software error occurred with the Checkpoint Facility (CF) application program
interface (API).
Recommended Action Verify that the system is running released software. If the problem persists,
copy the error message exactly as it appears, and report it to your technical support representative.
Error Message %CHKPT-3-IPCPORT: Unable to create IPC port on ([chars]).
Explanation
A severe checkpoint error occurred. The system was unable to allocate the resources
needed to create a communications port for the Interprocess Communications (IPC) channel needed
to transmit messages.
Recommended Action Verify that the system is running released software. If the problem persists,
copy the error message exactly as it appears, and report it to your technical support representative.
Error Message %CHKPT-3-IPCSESSION: Unable to open an IPC session for communicating
with ([chars]). rc= [dec]
Explanation
A severe checkpoint error occurred. The system was unable to establish an Interprocess
Communications (IPC) session between interfaces, which is needed to transmit messages.
Recommended Action Verify that the system is running released software. If the problem persists,
copy the error message exactly as it appears, and report it to your technical support representative.
Error Message %CHKPT-3-NOMEM: Unable allocate resource for CF on ([chars]).
Explanation
A severe checkpoint error occurred. The system was unable to allocate the necessary
resources (typically memory) on the indicated interface to create an Interprocess Communications
(IPC) channel for transmitting messages.
Recommended Action Verify that the system is running released software. If the problem persists,
copy the error message exactly as it appears, and report it to your technical support representative.
Error Message %CHKPT-3-RFREG: Unable to register checkpoint as client of RF.
Explanation
A severe checkpoint error occurred. The system was unable to register with the
redundancy facility (RF) so that it could begin the transmission of IPC messages between interfaces.
Recommended Action Verify that the system is running released software. If the problem persists,
copy the error message exactly as it appears, and report it to your technical support representative.
To Next Page
Loading...
Need help?
General