2-103
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
DIAG Messages
DIAG-4
Error Message %DIAG-4-CONFIG_REAPPLY: Please reapply config command [chars] after
the card is online.
Explanation
This message appears when the specified configuration command cannot be applied.
[chars] is the configuration command that you must reapply.
Recommended Action The system is working properly and the specified command cannot be applied.
Reapply the configuration command after the module is online.
DIAG-6
Error Message %DIAG-6-SCHEDULE_IS_REMOVED: [chars]: Schedule Diagnostic for [[chars]
[chars] [dec]:[dec].] is removed
Explanation
The scheduled online diagnostics test was removed because the test is no longer
applicable.
Recommended Action No action is required. The system is working properly.
Error Message %DIAG-6-SIMULATED_TEST_RESULT: [chars]: [chars] test result is
simulated.
Explanation
The result of the specified test is simulated. The message does not indicate a software
or hardware fault. The first [chars] is the message notification and the second [chars] is the test
name.
Recommended Action No action is required. The test failure is simulated as specified by the user.
Error Message %DIAG-6-SKIP_ONDEMAND_ACTIVE_TO_STANDBY_TEST: [chars]: [chars] cannot
be executed.
Explanation
The diagnostics test is bypassing the specified redundant test because the redundant test
cannot be executed.
Recommended Action No action is required. The system is working properly.
Error Message %DIAG-6-TEST_SKIPPED_FROM_ACTIVE: [chars]: [chars] cannot be executed
from active supervisor.
Explanation
The specified test cannot be run from the active supervisor engine.
Recommended Action No action is required. The test cannot be run, but the system is working
properly.
To Next Page
Loading...
Need help?
General