2-239
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
SNMP Messages
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %SMSC_RP-3-SSC_SSPA_SHUT: 7600-SSC-400 in slot [dec] is shutdown
because it cannot be set in single-spa-mode
Explanation
The specified slot has shut down because it could not be set in single-SPA mode.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
SMSC_RP-6
Error Message %SMSC_RP-6-INVALID_HW_VERSION: Single-spa-mode is not allowed for
7600-SSC-400 hardware version [dec].[dec].
Explanation
Only 7600-SSC-400 versions greater than 0.3 can be set in single-SPA mode.
Recommended Action To use single-SPA mode, use 7600-SSC-400 versions greater than 0.3.
SNMP Messages
This section contains Simple Network Management Protocol (SNMP) messages.
SNMP-5
Error Message %SNMP-5-MODULERESET: [chars] object has been set to ’reset’ for
[chars]=[dec] from IP address [chars].
Explanation
The SNMP server has reset a module.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General