2-10
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
C6K_MPLS_COMMON Messages
Error Message %BGP-3-MAXPFXEXCEED: No. of prefix received from [chars][chars][chars]
(afi [dec]): [dec] exceed limit [dec]
Explanation
The number of prefixes received from a neighbor has exceeded a configured limit.
Recommended Action Check the number of prefixes received from the neighbor and determine
whether the limit should be increased.
Error Message %BGP-3-PER_VRF_AGGR: pervrfaggr label: [chars]
Explanation
This message might appear when a prefix changes to a connected or BGP aggregate
type. The Tag Forwarding Information Base (TFIB) asks for a label for a prefix in the VRF routing
table. The per-VRF aggregate label will be assigned to the connected or BGP aggregate prefix when
BGP runs a best-path calculation.
Recommended Action No action is required. If this message recurs, contact your Cisco technical
support representative.
BGP-4
Error Message %BGP-4-MAXPFX: No. of prefix received from [chars][chars][chars] (afi
[dec]) reaches [dec], max [dec]
Explanation
The number of prefixes received from a neighbor has reached a warning limit.
Recommended Action Check the number of prefixes received from the neighbor and determine
whether the limit should be increased.
C6K_MPLS_COMMON Messages
This section contains Catalyst 6500 series switch and Cisco 7600 series router LAN and WAN
Multiprotocol Label Switching (C6K_MPLS_COMMON) messages.
C6K_MPLS_COMMON-3
Error Message %C6K_MPLS_COMMON-3-L2_CONFIG_NOT_RECOMMENDED: xconnect is configured
on interface vlans and WAN interfaces are facing the MPLS Core. Do not configure
LAN interfaces facing the MPLS Core.
Explanation
An attempt was made to configure a LAN interface to face the MPLS core. The current
network configuration has cross-connection services configured on interface VLANs and has WAN
interfaces facing the MPLS core.
Recommended Action Do not configure MPLS on LAN interfaces facing the MPLS core if the
network has cross-connect services configured on an interface VLAN and WAN interfaces that face
the MPLS core.
To Next Page
Loading...
Need help?
General