2-204
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
PM Messages
Error Message %PISAL2M-6-NBAR_PD_ACCEL_ENABLED: Protocol Discovery accelerated on
[chars] direction of: [chars]
Explanation
NBAR protocol discovery acceleration is enabled. This traffic will be sent to PISA.
Recommended Action No action is required.
Error Message %PISAL2M-6-NBAR_TAGGING_DISABLED: NBAR protocol Tagging disabled on
[chars] direction of: [chars]
Explanation
NBAR protocol tagging is disabled. This traffic will not be sent to PISA.
Recommended Action No action is required.
Error Message %PISAL2M-6-NBAR_TAGGING_ENABLED: NBAR protocol Tagging enabled on
[chars] direction of: [chars]
Explanation
NBAR protocol tagging is enabled. This traffic will be sent to PISA.
Recommended Action No action is required.
PM Messages
This section contains port manager (PM) messages.
PM-1
Error Message %PM-1-INCONSISTENT_PORT_STATE: Inconsistent HW/SW port state for
[chars]. Please shut/no shut the interface
Explanation
The hardware and software port state has become inconsistent. [chars] is the interface.
Recommended Action No action is necessary. This message is for informational purposes only.
PM-4
Error Message %PM-4-MPLS_MTU_EC_CFG: MPLS MTU size [dec] is not supported by one or
more ports in channel [chars].
Explanation
The MPLS MTU size that was configured on the Ethernet channel is larger than the
maximum MTU size that can be supported by one or more ports in this channel. Large packets might
be dropped.
Recommended Action Reduce the MPLS MTU size, or remove these ports from the channel before
increasing the MPLS MTU size.
To Next Page
Loading...
Need help?
General