2-205
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
PM_SCP Messages
Error Message %PM-4-MPLS_MTU_PORT_CFG: MPLS MTU size [dec] is not supported by port
[chars].
Explanation
The MPLS MTU size that was configured on the port is larger than the maximum MTU
size that can be supported by this port. Large packets might be dropped.
Recommended Action Reduce the MPLS MTU size.
Error Message %PM-4-PORT_BOUNCED: Port [chars] was bounced by [chars].
Explanation
During a switchover, the PM needed to perform a reactivation of a port that was in the
link-down state. A port is only reactivated when the port data structures lack consistency between
the active and redundant supervisor engines. Active ports in the link-down state were returned to the
link-up state by the reactivation event.
Recommended Action No action is required.
PM_SCP Messages
This section contains port manager Switch-Module Configuration Protocol (PM_SCP) messages.
PM_SCP-1
Error Message %PM_SCP-1-LCP_FW_ERR_POWERDOWN: Module [dec] will be powered down due
to firmware error: [chars]
Explanation
A nonrecoverable error was detected by the switching module firmware and the
switching module will be powered down to keep the system functioning. [dec] is the module number
and [chars] explains that the system will be powered down.
Recommended Action No action is required.
PM_SCP-2
Error Message %PM_SCP-2-TRANSCEIVER_INCOMPATIBLE: Transceiver inserted in [chars]
port [dec]/[dec] is not compatible with its interface (transceiver speed is
[chars], interface speed is [chars])
Explanation
An incompatible transceiver was inserted in the specified module. This transceiver
should not be used with this module.
Recommended Action Replace the specified transceiver with another transceiver that is compatible
with this module.
To Next Page
Loading...
Need help?
General